The Short Answer
The EcoFlow app connects to your power station over Wi-Fi or Bluetooth and lets you check charge level, toggle X-Boost, monitor input/output wattage in real time, and get low-battery alerts, all from your phone, even from another room. Wi-Fi gives you remote access when you're away from home; Bluetooth works up close without needing a network at all.
Midnight, the fridge just cycled on again, and instead of walking downstairs with a flashlight to check the power station's display, a quick glance at the phone on the nightstand shows 61% and climbing steady. That's the entire value proposition of the EcoFlow app in one moment, information without leaving bed.
What the App Actually Shows You
- Real-time battery percentage and estimated remaining runtime, calculated against your current load, not a fixed number.
- Live input and output wattage, useful for confirming a solar panel is actually delivering power, or catching an appliance drawing more than expected.
- X-Boost toggle, so you can enable the higher output ceiling only when needed, covered in depth in our X-Boost explainer, rather than leaving it on permanently.
- Low-battery push notifications, giving you a warning window before the unit actually cuts out, enough time to save work or start conserving load.
- Firmware update prompts, since EcoFlow periodically ships efficiency and safety improvements via software, not just hardware revisions.
Wi-Fi vs Bluetooth: Which to Use
| Connection | Range | Best for |
|---|---|---|
| Bluetooth | Short range, same room or nearby | Quick checks, no home Wi-Fi needed, works during a full internet outage |
| Wi-Fi | Anywhere with internet access | Checking your unit's status while at work or away from home |
The practical distinction most shoppers miss: if your home internet goes down along with the grid power (common when the same outage takes out your router), Wi-Fi monitoring stops working too, since the app needs an internet path back to the unit. Bluetooth still works in that scenario as long as your phone is physically nearby, which is worth remembering before assuming remote monitoring will always be available exactly when you need it most.
Scheduling and Smart Features
On units with app-enabled scheduling, you can set the unit to prioritize charging during specific hours, useful if you're on a time-of-use electricity plan and want to top up overnight when rates are lower, or set it to hold a minimum reserve charge rather than fully depleting, extending the battery's long-term cycle life. This level of control is one of the genuine differentiators between EcoFlow's smart units and a basic dumb battery pack that just charges and discharges with no logic in between.
A Small Business Use Case Worth Noting
For a shop owner monitoring a unit powering a chest freezer while away from the counter, this remote visibility is the difference between catching a low-battery alert with time to act and discovering a warm freezer the next morning. We cover this specific scenario in our small business backup power guide.
Setting It Up
Download the EcoFlow app, power on your unit, and pair via Bluetooth first (this works even before connecting to Wi-Fi). From there, add your home Wi-Fi network through the app's settings menu to enable remote access. The whole process takes under five minutes on any current RIVER or DELTA series unit, including the DELTA 3 and RIVER 3 Plus.
